Elation Professional LED 12 Brick II - Manual (Page 13)

Design LED 12 Brick II ™
©Elation Professional, Los Angeles Ca. 12 www.ElationLighting.com
Overhead mounting requires extensive experience, including amongst others calculating
working load limits, a fine knowledge of the installation material being used, and periodic
safety inspection of all installation material and the fixture. If you lack these qualifications, do
not attempt the installation yourself. Improper installation can result in bodily injury.
Be sure to complete all rigging and installation procedures before connecting the main
power cord to the appropriate wall outlet.
Mounting
The Design LED 12 Brick II ™ is fully operational in three different mounting positions,
hanging upside-down from a ceiling, side mounted, or set on a flat level surface. Be sure this
fixture is kept at least 0.5m away from any flammable materials (decoration etc.). When
clamp mounting; always use and install the supplied safety cable as an added safety
measure to prevent accidental damage in the event of a clamp failure. See the image
below.