Auriol Z31163 - Manual (Page 59)

59 GB/MT
Blinking display: Language:
RU Russian
EN English
Setting the wake-up time
This device has two wake-up times which can be set. They are set as follows:
1. Press the MODE / SET
20 button briefly in order to get to alarm mode.
Alarm 1 9 and Alarm 2 8 alternate on the display.
2. Now set the alarm you prefer by holding down the MODE / SET
button 20 until the hour display blinks.
3. Press the ▲ °C / °F 17 and ▼ ALARM ON / OFF buttons 16 to set the
desired value.
4. Confirm your setting by pressing the MODE / SET button. Repeat step
3 to set the minutes.
Note: The displays Alarm 1 and Alarm 2 indicate that the respective
alarm is switched on.
5. Switch the alarm time on or off by pressing the ▼ ALARM ON / OFF
repeatedly until the respective display appears or goes out.
Switching off the alarm signal
Press the SNOOZE- / LIGHT button 18 as the alarm signal sounds to
get to SNOOZE mode. The alarm signal sounds again after approx.
5 minutes. This process can be repeated 7 times.