beautypg.com

Hard disk error messages – Epson LT - 286e User Manual

Page 35

background image

Press

Y

and

Enter

to start the test. Press

N

and

Enter

to stop

the operation.

Hard Disk Error Messages

DIAG displays two types of error messages

while testing the

hard disk: messages DIAG generates and those the controller
generates.

DIAG displays the following message if you attempt to run the
Performance Test with less than 128KB of memory:

INSUFFICIENT MEMORY FOR DATA TRANSFER

Minimum memory required is - 128KB

The controller displays one of the following messages when an

error occurs during a diagnostics procedure:

Address mark not found
Attachment failed to respond

Bad ECC on disk read
Bad sector flag detected

Controller has failed
Drive activity failed

ECC corrected data error
Requested sector not found
Reset failed

Seek operation failed

Write fault on selected drive

When you see one of these error messages, check the drive,

controller, cables, and power connectors. Remove and re-install

the hard disk cartridge. If you still get an error, contact your

dealer.

30 System Diagnostics