Epson LT - 286e User Manual
Page 13
Type
T
and press
Enter
to run the selected tests in Timebound
mode. In Timebound mode, DIAG runs the tests for the
amount of time you specify.
Type C and press
Enter
to run the selected tests in Continuous
mode. In Continuous mode, the tests run until you interrupt
them.
Type
P
and press
Enter
to run the diagnostics tests in
Passbound mode. In Passbound mode, DIAG executes the
selected tests the number of times you specify. This is the
default setting.
The next prompt is:
W a i t o n e r r o r
( Y / N )
?
Y
Press
Y
and
Enter
if you want DIAG to pause when an error
occurs during a test. DIAG pauses and waits for you to press
Enter
before continuing. This lets you view the error message
and make notes about the error. This is the default setting.
Press
N
and
Enter
if you want DIAG to continue when an error
occurs.
The next prompt is:
E r r o r l o g g i n g
( Y / N )
?
N
Press Y and
Enter
to record the errors that may occur during
the test. See the “Error Logging” subsection for details.
Press
N
and
Enter
if you do not want to create the log. This is
the default setting.
If you decide not to wait on errors, you should select error
logging so you can review the errors that occur during the tests.
Next, DIAG requests information it needs to perform the type
of testing you selected.
8 System Diagnostics