Emerson MAYA ZEN CF750ORB00 - Manual (Page 12)

5. Unscrew the finial nut, hex jamnut, and
rubber lockwasher from the light kit
threaded nipple (Figure 22). Retain the
lockwasher, hex jamnut and finial nut
for future installation.
6. Position the glass shade over the
threaded nipple in the light kit plate
assembly (Figure 23). Seat the glass
shade evenly over the plate assembly
and securely install the rubber
lockwasher, hex jamnut, and finial nut
(previously removed) on the threaded
nipple.
NOTE: Periodically check that the glass
bowl is seated correctly in the light kit
assembly.
12
4. Screw three 60-watt (maximum)
candelabra base bulbs (not included) in
the light kit assembly sockets (Figure
22).
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and
not pinched between the ceiling
cover and the ceiling.
! WARNING
#8 EXTERNAL
TOOTH
LOCKWASHER (2)
CEILING
COVER
1-1/4"
THREADED
STUD (2)
#8-32 KNURLED
KNOB (2)
Figure 21
60-WATT (max.)
CANDELABRA BASE
BULB (3)
LIGHT KIT ASSEMBLY
SOCKET (3)
THREADED NIPPLE
RUBBER WASHER
FINIAL NUT
HEX JAMNUT
Figure 22
FINIAL NUT GLASS
SHADE
LIGHT KIT PLATE
ASSEMBLY
Figure 23
Final Assembly
1. Screw the two 1-1/4” threaded studs
(supplied) into the tapped holes in the
hanger bracket (Figure 20).
2. Lift the ceiling cover up to the threaded
studs and turn until studs protrude
through the holes in the ceiling cover
(Figure 21).
3. Secure the ceiling cover in place by
installing two lockwashers and two
knurled knobs (supplied) (Figure 21).
Tighten the knurled knobs securely
until the ceiling cover fits snugly against
the ceiling and the hole in the ceiling
cover is clear of the downrod.
7. Your ceiling fan is now installed and
wired and ready for use.
BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 12