Emerson Radio ES920 - Manual (Page 19)

18
Setting The Clock
When the system is connected to an AC outlet the time display will show a flashing
“AM 12:00 ”.
This is your indication that the time is incorrect
and needs to be set.
Note: Although it is not necessary to set the clock in order to listen to the radio
or CD player, the clock must be set correctly if you intend to use the timer to
turn the system ‘On’ and ‘Off’ automatically.
Set the clock as follows:
1.) Press the MEMORY button on front panel
or on remote control once.
The ‘Hour’ digits begin flashing.
2.) Repeatedly press the or buttons on front panel or remote control to
adjust the display to the correct hour, AM or PM.
3.) Press the MEMORY button again to set
the hour.
The ‘Minute’ digits begin to flash.
4.) Repeatedly press the or buttons on front panel or remote control to
adjust the display to the correct minute.
5.) Press the MEMORY button again.
Only the colon “ : ” continues flashing.
The clock begins to run.
ES920_102104.p65 21/10/2004, 12:06 18