Unpacking & set up, Pid controller – LW Scientific Slide Warmer User Manual

Page 2

P. 770.270.1394

F. 770.270.2389

865 Marathon Parkway Lawrenceville GA 30046

P. 770.270.1394

F. 770.270.2389

865 Marathon Parkway Lawrenceville GA 30046

Unpacking & Set Up

Carefully unpack the slide warmer and included power adapter, saving packing materials in the unlikely event you

need to return the item. Immediately contact your distributor if you detect any damage. If you need to return the

slide warmer to LW Scientific, please use the original packing material.

Place slide warmer on a flat, stable surface away from the edges. Ensure that the controls are set in the “OFF”

position.

Connect the included power adapter to the slide warmer, attach the provided line cord, and then plug it into a

properly grounded electrical outlet. (Use only the supplied power adapter and plug.)

Congratulations! You are now ready to use your LW Scientific Slide Warmer.

Caution: As with any temperature controlled equipment, take care not to touch the platform while the equipment

is in use. Hot surfaces can cause serious injury or burns.

LW Scientific is not responsible for any injury caused by misuse or abuse of this equipment.

PID Controller

All programming functions of the PID controller have been preset by LW Scientific, and the temperature has been

preset to 98.6°F (37°C). There are many complicated programming functions built into the PID controller, which should

not be altered by the customer. The only two functions that may need to be adjusted by the customer are “Set Tem-

perature” and “Change from Fahrenheit to Celsius” as described below. For any questions about altering other

programming, please contact the LW Scientific technical support department at 800-726-7345 (770-270-1394).

AL- Relay output indicator
Value increment/Select next parameter
Value decrement /Select previous parameter
Auto tuning /Digit shift
Set/Confirm
Will not illuminate
The temperature of the stage (Process Value, or PV) is displayed during operation. The target temperature (Set value

or SV) is displayed when flashing by pressing the V or key once.

3
4