Bang & Olufsen BeoVision 5 - Manual (Page 30)

RF/CHANNEL SETUP menu
To gain access to the menus required for
editing and fine-tuning channels, call up the
RF/CHANNEL SETUP menu. Here, you can gain
access to functions for adding or removing
channels, fine tuning, and selection of sound
type or SAP (Second Audio Program).
Add or remove stored channels
You can edit the number of available
channels. You can add a new channel or
remove a stored channel. In most cases, the
menu for adding or removing channels
appears automatically, once automatic tuning
has been completed, but you can also call it
up manually.
30
Edit and fine-tune channels
When you have connected
BeoVision 5 to either a cable network
or an antenna, and automatic tuning
has been performed, all available
channels are stored. However, it may
be necessary to edit channels.
Channels that do not broadcast
meaningful signals may still get
stored during tuning, or channels
may be excluded from tuning
because they were either out of reach
or the signal was too weak. In these
cases, you can remove empty channel
numbers or add those channels
which were excluded during
automatic tuning.
Editing or fine-tuning of a stored
channel may also be required if, for
example, the signal is weak, if you
want to select mono or stereo sound,
or if you want to add a Second Audio
Program, SAP, to a specific channel.
RF / CHANNEL SETUP
1 RF SETUP
2 ADD / REMOVE CHANNELS
3 FINE TUNE
select
ADD / REMOVE CHANNELS
RF INPUT ANT
ADD CHANNEL 4
REMOVE CHANNEL - -
add done
What’s on the ADD/REMOVE CHANNELS
menu…
(RF INPUT)
RF INPUT appears on the menu if you connect
cable or antenna to both RF IN sockets on the
BeoVision 5 top connection panel. Choose the
signal type, CABLE or ANT (antenna). You can
distinguish between two separate signals of the
same type – for example, two cable signals – by
selecting CABLE A or CABLE B.
ADD CHANNEL
If no channels are available to add, then this
option is dimmed and cannot be selected. If
channels can be added, then you can enter the
number of the channel you wish to add, and
press the green button on Beo4 to add it.
REMOVE CHANNEL
To remove stored channels, enter the number of
the channel you wish to remove and press the
green button on Beo4 to remove it.
While BeoVision 5 is on…
> Press MENU on Beo4 to call up the main
TV SETUP menu.
> Press 8 to call up the RF/CHANNEL SETUP menu
(9 if your BeoVision 5 is equipped with a
motorised stand).
> Press the number button that corresponds to
the menu item you want:
1 – ensure access to channels
2 – add or remove channels
3 – fine tuning or mono/stereo/SAP selection.
> Or, use ▼ ▲ to step to the item you want and
press GO to call up the selected menu.
Once you have completed menu operations…
> Press EXIT or a source button, such as TV or
SAT, to exit all menus or press STOP to back up
through previous menus.