Bang & Olufsen BeoVision 5 - Manual (Page 3)

3
DTS and DTS Digital Surround are registered
trademark of Digital Theater Systems, Inc.
DOLBY, DOLBY DIGITAL, PRO LOGIC and the
double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment
and receiver
– Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected
– Consult the retailer or an experienced radio/TV
technician for help
This class B digital apparatus meets all
requirements of the Canadian Interference-
Causing Equipment Regulations.
NOTE: This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
CAUTION: To reduce the risk of
electric shock, do not remove
cover (or back).
No User-serviceable parts
inside. Refer servicing to
qualified service personnel.
WARNING: To prevent fire or electric
shock, do not expose this appliance
to rain or moisture.
This symbol indicates that a
dangerous voltage
constituting a risk of electric
shock is present within this
unit.
This symbol indicates that
there are important
operating and maintenance
instructions in the literature
accompanying this unit.
Caution
To prevent electric shock, do not use the polarised
plug on the BeoVision 5 with an extension cord,
receptacle, or other outlet, unless the blades can
be fully inserted to prevent blade exposure.
Complete all the connections in your setup before
connecting any appliance to the AC outlet. Note:
Your BeoVision 5 operates on a normal household
current (120 volts, 60 Hz) and has a polarised
plug. Because one blade of the plug is wider than
the other, the plug fits in the wall outlet only one
way. Do not defeat the safety feature of this plug.
If you need an extension, use a polarised cord.
Note to Cable-TV installer
This reminder is provided to call your attention to
Article 820-22 of the National Electrical Code
(Section 54 of Canadian Electrical Code, Part 1)
which provides guidelines for proper grounding
and, in particular, specifies that the cable ground
shall be connected to the grounding system of the
building as close to the point of cable entry as
practical.