First-time setup of your television, Information – Bang & Olufsen BeoVision 10 Getting Started User Manual

Page 18

First-time setup of your television

Connections

TV positions

Select the type of equipment connected to each socket, the sockets used, 
the product name, and the source name. 

Position 1 is the far left position and Position 9 is the far right. Position 5 is 
the centre position.

Information

This first-time setup procedure is activated when the TV is connected to the mains 

and switched on for the first time. If you want to change your setup at a later date, 
you can access the same menus and update your settings. 

Switch on the TV

Wait for the TV to start up.

Switch on  

*NOTE! When you have selected the preferred 

settings in a menu, you may have to press the 
green button to continue to the next menu in the 

first-time setup procedure. Follow the on-screen 

instructions. 

Select settings

You are led through the first-time setup sequence 

when you switch on the TV for the first time.*

Some menus may not appear depending on your 

setup.

Select setting 

Accept and go to next menu item 

Set the on-screen menu language 

Make standby settings for the TV 
Register connected equipment 

This Getting Started describes operation with Beo4 in MODE 1 and the BEO4 SETTING menu set to 

NAVIGATION BUTTON, see also page 9. 

Please remember to set your Beo4 with navigation button to the MODE corresponding to the setting 
you make in the BEO4 SETTING menu, see the Beo4 Guide for further information. 

MENU LANGUAGE
STANDBY SETTINGS
CONNECTIONS