Bang & Olufsen BeoVision 10 Getting Started - Manual (Page 14)

Set up your television – BeoVision 10-40/46
Important
The television has several placement options. Follow the guidelines for placement
and connection.
Handling
We recommend that you place the TV in the
packaging while you fasten the wall bracket or the
bracket for the stand to the back of the TV.
Wall bracket and stand
Set the maximum angle the TV will turn on the
stand. The wall bracket can manually be turned 45˚
left or right depending on your setup. Remember
to leave enough space around the TV to allow it
to turn and tilt freely.
Placement options
The TV can be placed on a motorised stand or
mounted on a wall bracket. Refer to
www.bang-olufsen.com for available stands and
brackets or contact your Bang & Olufsen retailer.
Due to the weight of the TV, any moving or lifting
of the TV should be performed by qualified
personnel – using the proper equipment.
Three protection profiles have been enclosed with
the TV. Use these when moving the TV to avoid
scratching the frame.
Ventilation
Front glass
To ensure proper ventilation, allow enough space around the screen. Do not cover the fans. At over heating (flashing
standby indicator and an on-screen warning), switch the TV to standby, not off, in order for the TV to cool down.
You cannot operate the TV during this time.
If the front screen glass should crack or chip, or if it should be damaged in any way, it must be replaced immediately,
as it could otherwise cause injury. You can order replacement front screen glass from your Bang & Olufsen retailer.
14