Yaskawa SmartTrac DeviceNet Card - Manual (Page 41)

SMART TRAC DeviceNet Card
Technical Manual 3554-0070 Index
••
37
Index
A
address
memory 17
application protocol 5
B
Baud Rate
and MAC ID settings 20
baud rates 4
Bit Strobed I/O 3
C
Capabilities, Smart Trac DeviceNet
Card 3
Configuring the Smart Trac
DeviceNet Card 17
Connecting to a DeviceNet
Network 12–13
Connector 4, 9, 12–13, 24, 31, 32,
33
Connector, 5-pin 13
Controller Area Network 3, 6, 14,
27
CPU 31
D
data link layer 5–6
Default Settings 4, 17
DeviceNet Network Topology 6
Digital Operator 23
E
electrostatic sensitive discharge 11
ESD 11
ESD Procedures 2, 11
explicit messaging 3
extraction tool 32
F
fault manager 23
G
General Capabilities 3
global variables 23
ground 11
Grounding 19, 26
H
Help Desk 27
I
indicator lights 19–20, 19
information, safety 2
Installation
Termination and Signal Wires 19
Testing Card 19
Testing the Network 19
Installation, Smart Trac DeviceNet
Card 11
Interrupt 17, 24
Inverter 33
L
LEDs 19–20, 19
Module and Network Status at
Power-up 22
On-board Indicator Lights 19–20
Length
Both Thin and Thick Cables 8
Network 7
Line Length with both Thick and
Thin Cables 8
Line Length with Thin or Thick
Cable 7
M
MAC ID/ Baud Rate Settings 20
MAC-ID 6
Media Access Control Identifiers 6
media, transmission 5
Memory Address 17
messaging, explicit 3
Module and Network Status LEDs
at Power-Up 22
Module Status 20–22, 20–22