Yaskawa SmartTrac DeviceNet Card - Manual (Page 16)

SMART TRAC DeviceNet Card
12
••
Installing the Smart Trac DeviceNet Card Technical Manual 3554-0070
2CN
Connector
4CN
Connector
CPU Card
PG Card
PS Card
Ethernet
Card
Adapter
Ring
DeviceNet
card in one of
top two stack
positions in
stack
Card
PC/104
Optional
Smart Trac
Smart Trac
Smart Trac
Smart Trac
Card
Inverter Control
Main Chassis
Standoffs (4
places on top of
each card)
Figure 5. Smart Trac DeviceNet Card Stack Position
1. To install the DeviceNet card, orient the pins on the card with the
female pin connector on the card below it (normally the Ethernet card).
Gently but firmly push the Smart Trac DeviceNet card onto the card
below it. Make sure connecting pins are in alignment before pushing
the two boards tightly together. Secure the card using four (4) metal
standoffs.
2. Replace all other cards, securing each with four (4) metal standoffs and
the reverse of pertinent steps in "Appendix C – Removing the Smart
Trac Card Stack".