Yaskawa SmartTrac Ethernet Card - Manual (Page 15)

SMART TRAC Ethernet Card
Technical Manual Smart Trac Ethernet Card Installing the Smart Trac Ethernet Card
••
13
Connecting the Smart Trac Ethernet
Card to an Ethernet Network
1. Take one of the following three actions:
•
Using twisted pair cable for 10Base-T, plug the RJ-45 UTP cable
connector into the receptacle at the RJ-45 connector on the card.
•
If using an AUI Ethernet connector for 10Base5, connect the Thick
Ethernet RG-8 or RG-11 cable to the 16-pin AUI connector.
•
If using the optional 10Base-2 daughterboard, use either the BNC
connector for a T-connection to 10Base-2 thin cable ethernet or the
16-pin connection to the AUI port.
2. Route cable so that it is not routed along with A/C wires. Ethernet cable
should not be bundled. Before applying power to the system, inspect
the planned cable route to ensure it is not near A/C wires .