Yaskawa MP2600iec - Manual (Page 7)

Subject: Demo Instruction Product: MP2600iec Doc#: TN.MP2600iecDemo.01
Title: MP2600 Demo Instructions
Doc#: TN.MP2600iecDemo.01 Copyright Yaskawa Electric America
©2011
May 24, 2011
Page 7 of 29
8. Once the Hardware Configuration launches, connect to the controller on the demo case to go online.
Figure 5: Going online
9. When prompted to choose between offline configuration and the auto discovered configuration on the
controller, choose ‘Offline configuration’. This loads the configuration that was saved as part of the
demo application. Once connected and online, save the configuration. This step saves the
configuration to the controller. Once the configuration has been saved, disconnect the Hardware
Configuration from the controller and cycle power on the demo case.
10. Switch to MotionWorks IEC and “Make” the project. This will check the code for errors and warnings.
Click the “Project Control Dialog” button to download the IEC application code to the controller.
Figure 6: Project Control Dialog Window