Installing the option, 5 installation procedure – Yaskawa PG-E3 Motor Encoder Feedback User Manual

Page 12

5 Installation Procedure

YASKAWA ELECTRIC TOBP C730600 52C 1000-Series Option PG-E3 Installation Manual

◆

Installing the Option

Remove the front covers of the drive before installing the option. Refer to the drive manual

for directions on removing the front covers. Cover removal varies depending on drive size.

Shut off power to the drive, wait the appropriate amount of time specified on the
drive for voltage to dissipate, then remove the digital operator (E) and front covers

(D, F).

DANGER! Electrical Shock Hazard. Do not connect or disconnect wiring while the power is on. Before

wiring terminals, disconnect all power to the equipment. The internal capacitor remains charged even after

the power supply is turned off. After shutting off the power, wait at least the amount of time specified on the

drive before touching any components.

Figure 3

Figure 3 Remove the Front Covers and Digital Operator

This manual is related to the following products:

1000-Series Option PG-E3 Motor Encoder Feedback