SMA PT100U-NR - Manual (Page 11)

SMA Solar Technology AG Installation and Electrical Connection
Installation Guide PT100UNR-IEN083510 11
9. Connect the plug from the sensor lid with the screw
terminals - see image on the right. The polarity of the
cables can be chosen as desired.
10. Fasten the sensor lid to the enclosure using the screws
provided.
☑ The sensor is now connected.
4.5 Connecting the Sensor to the Sunny SensorBox
The sensor is connected at the "F6 TmpAmp" connection in the Sunny SensorBox. Proceed as follows:
1. Open the lateral flaps of the Sunny SensorBox using the recesses.
2. Loosen the screws in the corners of the Sunny SensorBox and open the enclosure lid towards
the left. The lid is connected to the lower shell by hooks.
ATTENTION!
Damage to the Sunny SensorBox due to liquids entering in.
• When working outdoors, make sure that no liquids (e.g. rain or snow) enter the open
Sunny SensorBox.
• When inserting and removing the cable
through the cable gland, make sure that
the grommet fits correctly into the cable
gland.
ATTENTION!
Damage to the Sunny SensorBox due to porous rubber seals
The rubber seal in the Sunny SensorBox lid becomes porous over time and will no longer
provide a tight seal if the Sunny SensorBox is opened. If you open the Sunny SensorBox
after an operating lifetime of more than 5 years, e.g. for upgrading the device, the rubber
seal in the Sunny SensorBox lid must be replaced with a new one. In this instance please
order a replacement seal before starting maintenance works.