ShoreLand'r SRV24 V.1 - Manual (Page 3)

FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame, remove
parts and sort by size.
TONGUE
The tongue comes shipped banded to the bunks.
Cut the banding and position the tongue into the
tongue channel of the frame.
Line the holes in the tongue with the holes in the
tongue channel. Install the 1/2” x 4” hex bolt in the
front cross hole and secure with a 1/2” lock nut.
Remove the wire harness from the rear of the tongue.
Place the wire harness and the brake line (If
equipped with brakes) through the hole provided in
the tongue cover plate. (See Detail A).
Secure the tongue cover plate in position with the
same 1/2” x 1-1/2” hex bolt that secures the back of
the tongue to the tongue channel of the frame.
Secure with a 1/2” lock nut. Tighten both bolts just
installed.
Plug the tongue wire harness ends into the frame
harnesses by matching colors and ends. Push the
extra wire provided either into the rear of the tongue
or else remove the grommets in the side frames and
place the extra wire in the side frame. Replace the
grommets just removed. Attach the ring on the white
ground wire to the main frame with the self-
tapping screw provided. A hole is provided in the
rear tongue channel support.
(FOR BRAKE INSTALLATION ONLY)
Locate the brass brake line coupling. Remove the
plastic cap and thread the brake line coming out the
rear of the tongue into one end of the coupling. Bend
the line in a smooth gradual radius being careful not
to kink the line. Bend so it can be mated to the brake
line from the side frame. Once aligned thread the
side frame brake line into the other end of the
coupling. Tighten both lines into the coupling.
SAFETY CHAINS
The safety chains are shipped installed.
SPRINGS
The springs are shipped already installed to the axle.
It is ready to install to the frame.
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M301236
Page 3 of 12