ShoreLand'r SRV24 V.1 - Manual (Page 10)

Drum Brake Axle Assembly
Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M301236
Page 10 of 12
ONE AXLE DRUM BRAKE INSTALLATION
Cut the tape securing the brake line hose to the axle. Place
the end of the hose up through the hole provided in the brake
line clip bracket. Secure in place with the hose clip provided.
Remove the plastic cap from the end of the frame brake line
coming out of the side frame by the axle. Carefully uncoil the
brake line so that it will reach the end of the hose just
attached to the brake line clip bracket. Thread the brake line
fitting into the brake line hose. Tighten. The axle assembly
has been pre-bled at the factory during assembly.
Fill the actuator reservoir with brake fluid and bleed the line
per the instructions in the brake manual. All bleeding to the
line can be done through the bleeder on the right wheel
cylinder For bleeding instructions see the ShoreLand’r
Owners Manual.
ONE AXLE DISC BRAKE INSTALLATION
(Galvanized Models Only)
Cut the tape securing the brake line hose to the axle.
Remove the brass plug from the port in the brass block on
the right brake caliper. Thread the brake hose male end into
the port from which the plug was removed and tighten. Place
the other end of the hose up through the hole provided in the
brake line clip bracket. Secure in place with the hose clip
provided.
Remove the plastic cap from the end of the frame brake line
coming out of the side frame by the axle. Carefully uncoil the
brake line so that it will reach the end of the hose just
attached to the brake line clip bracket. Thread the brake line
fitting into the brake line hose. Tighten. The axle assembly
has been pre-bled at the factory during assembly. All
bleeding to the line can be done through the bleeder on the
right caliper. For bleeding instructions see the ShoreLand’r
Disc Brake Manual.