ShoreLand'r LUB40TABXLW - Manual (Page 15)

LU0106 Lund Load Assembly
Instructions
The LU0106 load guides are designed to fit on the
Lund boat trailers manufactured with 2 x 4 side frame
tubing .The length of the mounting U-bolts provided
will accommodate this size tubing only. Mounting on a
smaller or larger side frame tube may not be possible
because of the U-bolt length. .
Remove all items from the box and sort by size.
Note that the arm weldments of the load guide are
identical so there is no right or left part.
Locate the arm weldments and the carpeted bunks.
Attach the carpeted bunks to the arm weldments
using the 5/16” x 1 ½” hex bolt and lock washers
provided. Tighten.
Make sure the boat is centered on the trailer before
attempting to install the load guides.
Position one of the load guide assemblies on the top
side of the side frame and move in or out until the
desired clearance has been established between the
load guide and the boat. Select the proper pair of
holes that you will use to mount the arm weldments to
the side frame.
Locate two of the ½” x 2 9/16” x 5 ½” U-bolts. Drop
them down through the holes in the arm weldments
just identified as shown in the diagram. Place the U-
bolts so one of the U-bolt legs is on each side of the
side frame. Place one of the metal plates provided
onto the legs of the U-bolts. Secure with ½” flange
lock nuts.
Slide the load guide forward or backward on the
frame until the rear of the load guide does not extend
past the rear of the boat. Tighten the load guide in
this position.
Repeat the above process on the load guide for the
other side of the trailer.
Assembly is complete.
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004056
Page 15 of 18 Rev A 08/11/2011