ShoreLand'r SLIB55TBBL - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004169
Page 9 of 14 Rev A 10/20/2010
ONE AXLE BRAKE INSTALLATION
Cut the tape securing the brake line
hose to the axle. Remove the plastic
plug from the port in the bottom of the
brass block on the right brake caliper.
Thread in the brake hose male end and
tighten. The port on the left side of axle
has only one port, remove the plastic
plug and insert the axle brake hose.
Carefully pull brake line hose from the
side frame tube, threading it through
the brake line clip and down to the side
port in the brass block on the right
caliper. Remove the plastic cap and
thread into the port on the brass block
and tighten. Insert grommet into the
brake line clip to protect hose. All
bleeding of the line can be done
through the bleeder on the caliper.
Fill the actuator reservoir with brake
fluid and bleed the line per the
instructions in the brake manual. All
bleeding to the line can be done
through the bleeders on the left
calipers.