Rear bunk assembly – ShoreLand'r SL82TAL User Manual
Page 10
Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorelandr.com
0003356
REV G 4/28/06
Page 10
Mount the rear bunk support weldments to the pivot weldments by placing them in the channel of the pivot
weldments and attaching with 1/2” x 4-1/2” stainless steel hex bolts and 1/2” stainless steel lock nuts. Place
the bunk assembly over the support weldment, align the holes of the bunk brackets with the holes in the
support weldment and secure using 1/2” x 1 1/2” stainless steel hex bolts and 1/2” stainless steel lock nuts. Tighten but do
not over tighten because the bunks must rotate to conform to the boat bottom.
Note: The bunk pivot base weldment is adjustable on the front cross. Loosen the 1/2” U-bolts (Item #3,
Page 14) enough to move the bunk pivot base weldment in or out on the front cross to a location that best
conforms to your watercraft.
Rear Bunk Assembly:
Rear Bunk Assembly