Safety instructions – ShoreLand'r SL150TAL User Manual

Page 7

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0002876

Page 7

REV C 11/02/05

��

��

Refer to your

Owner’s Guide and other decals on

trailer for additional information.

SAFETY INSTRUCTIONS

4810709

Before towing, check the following to
ensure that:
1. All parts, bolts, nuts and wheel

lugnuts are tight.

2. Tiedowns, winch strap and

bow-eye safety chain are secure.

3. Tires are inflated to manufacturer’s

standards.

(see tire sidewall)

4. Wheel bearings have adequate

grease.

5. Trailer coupler and coupler ball

are the same size.

6. Coupler is properly attached and

secured to coupler ball.

7. Trailer safety chains are crossed

under the tongue and attached to

towing vehicle.

8. All lights are operational.

Note: It is recommended that the

trailer lights be disconnected before

backing into the water.

9. Trailer tongue jack is in up or

travel position.

Proper tongue weight must be maintained.

Rev A 3/23/05

Winch Assembly:

Refer to page 6 for winch parts diagram.

The winch post assembly comes factory assembled

and ready to mount on the tongue. Position the winch

assembly on the tongue in a location that would best

ﬁt your watercraft. Using two (2) 5/8” X 5-3/4” X 6-3/4”

stainless steel square u-bolts, secure the winch assem-

bly to the tongue. Tighten with four (4) 5/8” stainless

steel lock nuts so that the winch assembly will not slide

on tongue. Set the other mounting plate in position and

secure it using two (2) 5/8” X 5-3/4” X 6-3/4” stainless

steel square u-bolts and four (4) 5/8” stainless steel

lock nuts. Refer to winch adjustments on page 14.