ShoreLand'r SL150TAL - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0002876
Page 4 REV C 11/02/05
Tongue:
Slide the tongue into the tongue channel weldment on
front crossmember. Secure the tongue with a 5/8” X 7”
stainless steel hex bolt, 5/8” stainless steel flat washer
and 5/8” stainless steel hex lock nut with nylon insert.
Secure the tongue to the tongue plate on the frame
using two (2) 5/8” X 5-3/4” X 6-1/2” square u-bolts and
four (4) 5/8” stainless steel hex lock nut with nylon in-
serts.
Wiring
The tongue comes from the factory already pre-
assembled. The wire harness is installed and threaded
into the locations required for it to be connected to the
frame once the tongue is installed. Do not connect any
of the wiring from the tongue to the wiring in the frame
until the tongue is fully installed.
Front Tongue Wires:
1 white wire w/ground ring
1 brown wire w/female plug
2 brown wires w/male plugs
• Place white wire with grounding ring on the top side
of the flat aluminum plate connecting the bottom flang-
es of the two side frame together. Place the self-tap-
ping screw into the ring of the white wire and drill onto
the flat plate creating a positive ground.
• Connect the brown wire with the female plug to the
violet wire from the battery box.
• Plug the two brown wires with male plugs into the
yellow clearance lights on front side frames of trailer.
Rear Tongue Wires:
1 blue/brown w/2-pin connector
1 black/violet w/2-pin connector
1 brown/yellow w/2-pin connector
1 brown/green w/2-pin connector
• Plug the blue/brown with 2-pin connector into the
jumper wire connected to the actuator.
• Plug the black/violet with 2-pin connector into the
jumper wire connected to the actuator.
• Plug the brown/yellow with 2-pin connector into the
frame wire harness for lights on the left side of the trail-
er.
• Plug the brown/green with 2-pin connector into the
frame wire harness for lights on the right side of the
trailer.
Refer to Page 14 for the complete wire diagram
drawing.
Coupler / Safety Chain:
Mount the coupler onto the tongue (matching the hole
pattern) using four (4) 5/8” X 1-3/4” stainless steel hex
bolts and four (4) 5/8” stainless steel hex lock nuts with
nylon inserts.
Mount the safety chains to the front of the tongue us-
ing a 1/2” X 1-1/2” stainless steel hex bolts, followed
by a 1/2” stainless steel flat washer and safety chain.
Secure this assembly on the inside of the tongue us-
ing a 1/2” stainless steel hex lock nut with nylon insert.
Repeat the above instructions on the other side of the
tongue.
Jack:
Remove the hardware bag provided by the jack
manufacturer and take out the mounting plates.
From hardware bag (66270), take out four (4) 3/8”
X 6” stainless steel hex bolts and four (4) 3/8” stain-
less steel lock nuts with nylon inserts, Position the
jack on the tongue in a location that best fits your
watercraft. Secure with the stainless steel hardware.
The remaining hardware bag that was removed from
the jack may be discarded.