ShoreLand'r 2x5 - Manual (Page 8)

Final Assembly Instructions
Remove the small parts from the frame by cutting the
bands. Remove the bolt bag and sort all nuts and bolts by
size.
Tongue:
Slide the tongue into the frame cap of the frame. Line up
the holes and fasten the tongue in the side of the frame
cap with a 1/2” X 4-1/4” hex bolt and 1/2” flange lock nut.
Fasten the tongue in the rear of the frame cap with a 1/2” X
1-1/2” hex bolt and 1/2” hex lock nut. Plug the tongue
harness into the frame harness, use grommets to secure
the wires in the wire holes.
Actuator & Safety Chain:
Slide the actuator into the actuator housing unit and secure
with two (2) pins and snap rings provided with the actuator.
Secure the actuator-housing unit to the front of the tongue
using three (3) 1/2” X 4” hex bolts and 1/2” flange lock
nuts. Using a 1/2” X 5” hex bolt on the lower right mounting
hole on the tongue, secure the safety chain. Place a 1/2”
flat washer on the 1/2” X 5” hex bolt followed by one (1)
safety chain and insert into the actuator housing unit and
the tongue. Place a second safety chain on the bolt
followed by a 1/2” flat washer and 1/2” flange lock nut.
Roller Assembly:
Mount the 60615-- (53-1/2” rack arm/12-roller) assembly
on the rear pivot in a desired location that best fits your
boat. Secure this assembly by using a 1/2” X 4” carriage
bolt and a 1/2” flange lock nut. Repeat on opposite side.