ShoreLand'r 2x5 - Manual (Page 27)

REF# PART# DESCRIPTION QTY
1 60972 ROLLER WITH MOLDED HUB 6IN ......... 12
2 0110118 HH 1/2-13 X 4 1/2 CS GR5 ........................ 2
3 0210127 CARR 3/8-24 X 3 W/1 THRD GR8 ............ 8
4 0210218 CARR 1/2-13 X 4 GR5 ............................... 1
5 1310121 WASHER USS ALUMINUM FLAT 3/4 ....... 12
6 1440100 HEX LOCKNUT 3/8-24 GRA ..................... 8
7 1440102 FLANGE LOCKNUT SMALL 1/2-13 .......... 3
8 1540350 BULL RING PLAIN ..................................... 12
9 S-3184 PLASTIC MOLDED SWIVEL BLOCK ........ 4
10 S-3368 INLINE ROLLERPIN 19 1/2 ....................... 4
11 S-3383 ROLLER BUSHING MOLDED ................... 12
12 S-3384 FLAT WASHER 2OD X 1.150ID ALUM ... 12
13 S-3410 T BAR ROLLERPIN ................................... 2
14 S-3480 ROLLER ARM 18&7/8 ............................... 2
15 S-3482 ROLLER RACK ARM WMENT 53&1/2 .... 1
Made in the USA Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 0002910
www.shorelandr.com REV 8/31/00
66212-- 12-Roller Rack Arm Assembly
®
Rear Roller Rack:
The rear roller rack is factory assembled.
Rear Roller Rack Adjustments:
Place the boat onto the trailer so that it is resting on the rollers in
the back of the trailer and on the front keel support rollers up front.
Position the boat front to back by having the center of the rear
roller approximately 4” from the transom. The boat must be
positioned so that it supported by the rollers. Once the boat is
positioned make the following roller adjustments.
Position the racks in back so that they are located between the
keels or strakes and so that they won’t interfere when loading and
unloading. Once positioned, tighten the u-bolts in the mounting
brackets. The up-down adjustment in the rear adjustable mounting
bracket should be in its down position whenever possible to keep
the center of gravity lower to the ground for better trailering. The
upper position should be used only when the fender or frame
clearance is needed.