ShoreLand'r 2x5 - Manual (Page 21)

REF# PART# DESCRIPTION QTY
1 6107503 END CAP - BLACK PROFILE 2000 .......... 4
2 0110114 HH 1/2-13 X 4 CS GR5 .............................. 3
3 0110125 HH 1/2-13 X 5 1/2 CS GR5 ........................ 2
4 0140040 HH 3/8-16 X 1 CS GR5 .............................. 3
5 0140090 HH 1/2-13 X 1 CS GR5 .............................. 2
6 0210102 CARR 3/8-16 X 1 GR5 ............................... 1
7 0340200 SUB 1/2 X 3 9/16 X 6 W/2 3/8 THR .......... 2
8 1310040 LOCKWASHER 1/2 S/T MED .................... 3
9 1340095 WASHER USS FLAT 3/8 ........................... 2
10 1440101 FLANGE LOCKNUT SMALL 3/8-16 .......... 4
11 1440102 FLANGE LOCKNUT SMALL 1/2-13 .......... 8
12 1440159 HEX NUT FINISH 1/2-13 ........................... 3
13 2210145 CHAIN 1/4(7MM)X 10 LINKS .................... 1
14 3110242 WINCH HANDLE ....................................... 1
15 3110345 WINCH DL1800A W/STRAP-NO HANDLE 1
16 3510065 4" BOW ROLLER - BLACK ........................ 2
17 3510539 CAP BLACK FOR 3X4 WINCH CAP ......... 1
18 LH308 CUP WASHER ........................................... 4
19 S-534 WINCH POST ............................................ 1
20 S-2266 22&3/4” WINCH HOLDER CHANNEL ....... 1
21 S-2268L BOW PIVOT PLATE - LEFT ...................... 1
22 S-2268R BOW PIVOT PLATE - RIGHT .................... 1
Made in the USA Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 0002908
www.shorelandr.com REV 8/31/00
SL WINCH ASSEMBLY
®
Winch Post:
Position the winch post assembly on the tongue of your trailer.
Secure with two (2) 1/2” X 3-9/16” X 6” square u-bolts and 1/2”
flange lock nuts. Leave loose for adjustment. Fasten the winch
handle to the winch.
Bow Eye Safety Chain:
Insert a 3/8” X 1” carriage bolt from the top through the square
hole at the end of the winch holder channel. Place the last link of
the safety chain onto the bolt, then 3/8” flat washer and 3/8” flange
lock nut. Tighten.
Winch Post Adjustment:
Once the boat is positioned on the trailer, adjust the winch post to
the boat. Loosen the three (3) 1/2” X 4” hex bolts and move the
winch bracket so that the top rubber bow roller is above the bow
eye. Tighten.
Slide the winch post assembly against the boat. Tighten the u-
bolts. Adjustment is complete. Check the tongue weight before
tightening the u-bolts.