Symmetry tolerance, 1 oper ation – HEIDENHAIN IK 5000 Addendum User Manual
Page 70
70
1 Operation
1
.1 Oper
ation
Symmetry tolerance
A symmetry tolerance can be applied to Line and Plane features that
are symmetrical to a reference feature.
Symmetry tolerance applied to a line
To apply the symmetry tolerance to a line:
Measure four lines, two lines on opposite sides that are considered
to be master edges and two lines from edges that are to be
symmetrically toleranced. Lines 1 and 2 are measured from master
edges while lines 3 and 4 are measured from the edges to be
symmetrically toleranced.
Construct a reference line from lines 1 and 2
Construct the line to be tolerance for symmetry from lines 3 and 4
Select the resultant line from the construction using lines 3 and 4
/LQH
/LQH
7ROHUDQFHG OLQH
5HIHUHQFH OLQH
/LQH
/LQH