HEIDENHAIN IK 5000 Addendum - Manual (Page 40)

40 1 Operation
1
.1 Oper
ation
Profile3D measurement screen functions
Functions for conducting Profile3D measurements are located across
the bottom of the Measure Profile3D window. These functions are
discussed in detail later in the Profile3D measurement instructions.
The Measure Profile3D window functions are shown below:
Measure Profile3D window
Functions Function descriptions
OK Complete the Profile3D measurement
Enter Pt Probe part surfaces
Remove Last Remove the last probed points
Cancel Cancel the Profile3D measurement
Fit Fit probed data to the nominal Profile3D
Reset Reset the fit operation
Export Export the adjusted Profile3D model
Tolerance Assign surface tolerances
Allow X, Y, Z Allow (or prohibit) data shifts during Profile3D fit analyses
Allow AX, AY, AZ Allow (or prohibit) data rotation during Profile3D fit analyses
Pass Only Enable (or disable) Pass Only option