HEIDENHAIN IK 5000 Addendum - Manual (Page 3)

IK 5000 QUADRA-CHEK 3
Information contained in this
manual
This addendum covers the operating and setup feature additions and improvements implemented in IK 5000 Software v3.0.x.
For OEM setup feature additions refer to the IK 5000 QUADRA-CHEK OEM Addendum (ID 1041353-2x), available by request
from HEIDENHAIN.
Minimum system requirements
Backward compatibility
The IK 5000 QUADRA-CHEK v3.0.x software version is compatible with several previous versions down to version 2.93.0. It
can be used to update any prior version starting at version 2.93.0 and up. To update a previous version refer to “Software
Updates” below.
Software updates
End users should only update the IK 5000 software after consultation with the machine manufacturer. Observe the system
requirements as described in “Minimum System Requirements” above. For software updating procedures, refer to " Updating
the IK 5000 software on page 78”.
Fonts used in these instructions
Items of special interest or concepts that are emphasized to the user are shown in bold type.
Software controls and Windows are shown in letter gothic bold type.
Component w/o 3D Profiling w/ 3D Profiling
PC 2.66 GHz dual-core Pentium 2.8 GHz quad-core Pentium
Operating System (OS)  Windows XP
 Windows Vista 32-bit
 Windows 7 32-bit, Windows 7 64-bit
 Windows 8 32-bit, Windows 8 64-bit
RAM 1GB 2GB
Available Hard Disk 500MB 1GB
PCI 1 PCI slot and 1 to 3 additional empty slots (depending on the version)
Note: PCI Express slot required for PC2-COMP Express frame grabber board, refer to "PC2-
COMP Express frame grabber board on page 80”. The PC2-COMP Express frame grabber
board is compatible with 32-bit operating systems only.
Video Display Unit 1024 x 768 resolution
Windows users rights Administrator