HEIDENHAIN TNC 640 (34059x-02) Cycle programming - Manual (Page 580)

Index
580
TNC 640 | User's Manual Cycle Programming | 5/2013
Side finishing............................ 191
Single-lip deep-hole drilling......... 93
SL Cycles......................... 176, 203
Contour cycle......................... 178
Contour data.......................... 183
Contour train.......................... 193
Floor finishing......................... 190
SL cycles
Fundamentals......................... 176
Fundamentals......................... 226
SL Cycles
Pilot drilling............................ 185
Roughing................................ 187
Side finishing.......................... 191
Superimposed contours. 179, 220
SL cycles with complex contour
formula..................................... 216
SL cycles with simple contour
formula..................................... 226
Slot milling
Roughing+finishing................ 145
Spindle orientation................... 272
T
Tapping
With a floating tap holder....... 101
With chip breaking................. 107
Without a floating tap
holder............................. 104, 107
Thread drilling/milling............... 120
Thread milling/countersinking... 116
Tilting function
Procedure............................... 264
Tilting the working plane.. 259, 259
Cycle...................................... 259
Tolerance monitoring................ 471
Tool compensation................... 472
Tool measurement........... 558, 562
Calibrate TT.................... 564, 565
Machine parameters.............. 560
Measuring tool length and
radius..................................... 570
Tool length............................. 566
Tool radius.............................. 568
Tool monitoring........................ 472
Touch probe cycles
For automatic mode............... 388
Touch probe data...................... 394
Touch probe table..................... 393
Turning cycles.................. 280, 289
Axial recessing....
341,
349, 363, 369
Contour face.......................... 325
Contour longitudinal............... 303
Contour-parallel....................... 307
Radial recessing............. 329, 353
Recessing, axial extended.... 344,
365
Recessing, radial extended....
332,
356
Recessing contour, radial.... 337,
360
shoulder, longitudinal extended....
292
Shoulder face......................... 311
Shoulder face extended......... 314
Shoulder longitudinal.............. 290
Thread, contour-parallel.......... 379
Thread, extended................... 375
Thread, longitudinal................ 372
Transverse plunge.................. 318
Transverse plunge extended.. 321
Turn, longitudinal plunge......... 296
Turn, longitudinal plunge
extended................................ 299
U
Universal drilling................... 80, 86
W
Workpiece Measurement......... 468