HEIDENHAIN TNC 640 (34059x-02) Cycle programming User Manual
Page 41
TNC 640 | User's Manual Cycle Programming | 5/2013
41
18 Touch Probe Cycles: Special Functions........................................................................................ 511
18.1 Fundamentals....................................................................................................................................... 512
Overview................................................................................................................................................ 512
18.2 MEASURE (Cycle 3)..............................................................................................................................513
Cycle run.................................................................................................................................................513
Please note while programming:........................................................................................................... 513
Cycle parameters................................................................................................................................... 514
18.3 Calibrating a touch trigger probe....................................................................................................... 515
18.4 Displaying calibration values.............................................................................................................. 516
18.5 CALIBRATE TS (Cycle 460, DIN/ISO: G460)....................................................................................... 517
18.6 CALIBRATE TS LENGTH (Cycle 461, DIN/ISO: G461)....................................................................... 519
18.7 CALIBRATE TS RADIUS INSIDE (Cycle 462, DIN/ISO: G462)........................................................... 520
18.8 CALIBRATE TS RADIUS OUTSIDE (Cycle 463, DIN/ISO: G463)....................................................... 522