HEIDENHAIN TNC 620 (34056x-04) - Manual (Page 427)

Using 3-D touch probes (Touch Probe Function software option) 13.5
13
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
427
13.5 Using 3-D touch probes (Touch Probe
Function software option)
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function Soft key Page
Calibrating the effective length 435
Calibrating the effective radius 436
Measuring a basic rotation using a
line 440
Setting a datum in any axis 442
Setting a corner as datum 443
Setting a circle center as datum 445
Setting the centerline as datum 447
Touch probe system data
management See User’s
Manual for
Cycles
For more information about the touch probe table,
refer to the User’s Manual for Cycle Programming.