HEIDENHAIN TNC 620 (34056x-04) - Manual (Page 36)

Contents
36
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
13 Manual operation and setup.........................................................................................................403
13.1 Switch-on, switch-off........................................................................................................................... 404
Switch-on................................................................................................................................................ 404
Switch-off................................................................................................................................................406
13.2 Moving the machine axes................................................................................................................... 407
Note........................................................................................................................................................ 407
Moving the axis with the machine axis direction buttons..................................................................... 407
Incremental jog positioning....................................................................................................................407
Traverse with electronic handwheels.....................................................................................................408
13.3 Spindle speed S, feed rate F and miscellaneous function M.......................................................... 418
Application.............................................................................................................................................. 418
Entering values.......................................................................................................................................418
Adjusting spindle speed and feed rate.................................................................................................. 419
13.4 Datum setting without a 3-D touch probe........................................................................................ 420
Note........................................................................................................................................................ 420
Preparation..............................................................................................................................................420
Workpiece presetting with axis keys..................................................................................................... 420
Datum management with the preset table........................................................................................... 421
13.5 Using 3-D touch probes (Touch Probe Function software option).................................................. 427
Overview................................................................................................................................................ 427
Functions in touch probe cycles............................................................................................................ 428
Selecting touch probe cycles................................................................................................................. 430
Recording measured values from the touch-probe cycles.....................................................................431
Writing measured values from the touch probe cycles in a datum table.............................................. 432
Writing measured values from the touch probe cycles in the preset table........................................... 433
13.6 Calibrating a 3-D touch trigger probe (software option Touch probe functions)........................... 434
Introduction.............................................................................................................................................434
Calibrating the effective length.............................................................................................................. 435
Calibrating the effective radius and compensating center misalignment.............................................. 436
Displaying calibration values.................................................................................................................. 438