HEIDENHAIN TNC 620 (34056x-04) - Manual (Page 41)

TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
41
16 MOD functions................................................................................................................................491
16.1 MOD function....................................................................................................................................... 492
Selecting MOD functions.......................................................................................................................492
Changing the settings............................................................................................................................ 492
Exiting MOD functions...........................................................................................................................492
Overview of MOD functions..................................................................................................................493
16.2 Position Display Types......................................................................................................................... 494
Application.............................................................................................................................................. 494
16.3 Unit of Measurement...........................................................................................................................495
Application.............................................................................................................................................. 495
16.4 Displaying operating times................................................................................................................. 495
Application.............................................................................................................................................. 495
16.5 Software numbers................................................................................................................................496
Application.............................................................................................................................................. 496
16.6 Entering the code number.................................................................................................................. 496
Application.............................................................................................................................................. 496
16.7 External access..................................................................................................................................... 497
Application.............................................................................................................................................. 497
16.8 Setting up data interfaces...................................................................................................................498
Serial interfaces on the TNC 620.......................................................................................................... 498
Application.............................................................................................................................................. 498
Setting the RS-232 interface.................................................................................................................. 498
Setting the BAUD RATE (baudRate)...................................................................................................... 498
Setting the protocol (protocol)............................................................................................................... 499
Setting data bits (dataBits).....................................................................................................................499
Check parity (parity)............................................................................................................................... 499
Setting the stop bits (stopBits).............................................................................................................. 499
Setting handshaking (flowControl)......................................................................................................... 500
File system for file operations (fileSystem)........................................................................................... 500
Settings for data transfer with the TNCserver PC software.................................................................. 500
Setting the operating mode of the external device (fileSystem)........................................................... 501
Data transfer software........................................................................................................................... 502