HEIDENHAIN MANUALplus 4110 Instructions for engraving cycles - Manual (Page 9)

August 2005 Engraving 7
Character string “Zyklen- und” (“Cycles and”)
The character string is engraved linearly at an angle.
Programming the character string:
8 Position the tool to XK = 39, YK = –4
8 Parameters for subprogram call:
„ Letter height: LA=6 mm
„ Angle: LB=215°
„ Milling depth to Z=0 (LC=0)
„ Retraction plane to Z=3 (LD=3)
„ Engraving on the front face (LE=0)
„ Linear character string (LF=0)
„ Separation factor: 1.6 * default separation (I=1.6)
Example: Program and block structure
. . .
N48 G100 XK39 YK-4
N49 L"Z" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N50 L"KY" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N51 L"KK" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N52 L"KL" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N53 L"KE" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N54 L"KN" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N55 L"MINUS" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N56 L"BLANK" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N57 L"KU" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N58 L"KN" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N59 L"KD" LA6 LB215 LC0 LD3 LE0 LF0 I1.6
N.. . . .