HEIDENHAIN MANUALplus 4110 Instructions for engraving cycles - Manual (Page 11)

August 2005 Engraving 9
1.4 Example: Engraving the Lateral Surface
Character string “Steuerungen”
The character string “Steuerungen” (“Controls”) is
engraved from –CY to +CY.
Programming the character string:
8 Position the tool to Z=–110 and C=–45°
8 Parameters for subprogram call:
„ Letter height: LA=12 mm
„ Angle: LB=0° (from –CY to +CY)
„ Milling depth to diameter 120 (LC=120)
„ Retraction depth to diameter 126 (LC=126)
„ Engraving on the lateral surface (LE=1)
„ Linear character string (LF=0)
„ Diameter (for G120): LH=120
„ Separation factor: 1.3 * default separation (I=1.3)
Example: Program and block structure
. . .
N5 G110 C-45
N6 G0 X126
N7 G0 Z-110
N8 L"S" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N9 L"KT" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N10 L"KE" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N11 L"KU" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N12 L"KE" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N13 L"KR" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N14 L"KU" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N15 L"KN" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N16 L"KG" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N17 L"KE" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N18 L"KN" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N19 L"BLANK" LA12 LB0 LC120 LD126 LE1 LF0 LH120 I1.3
N.. . . .