HEIDENHAIN MANUALplus 4110 Instructions for engraving cycles - Manual (Page 6)

4 HEIDENHAIN MANUALplus 4110
1.3 Example: Engraving the Front Face
The following sample program engraves character
strings in various orientations and positions onto the
front face.
Character string “HEIDENHAIN”
The character string is engraved in polar alignment,
bent upwards, at Z = –10.
Programming the character string:
8 Position the tool to C=–35°
8 Parameters for subprogram call:
„ Letter height: LA=15 mm
„ Milling plane at Z=–10 (LC=–10)
„ Retraction plane at Z=–7 (LD=–7)
„ Engraving on the front face (LE=0)
„ Polar character string bent upwards (LF=1)
„ Diameter over which the character string is
engraved (LH): Bottom edge of character=85
„ Separation factor (I) is not programmed; the
default separation is valid Example: Program and block structure
. . .
N5 G0 X60 Z5
N6 G0 Z-5
N7 G110 C-35
N8 L"H" LA15 LC-10 LD-7 LE0 LF1 LH85
N9 L"E" LA15 LC-10 LD-7 LE0 LF1 LH85
N10 L"I" LA15 LC-10 LD-7 LE0 LF1 LH85
N11 L"D" LA15 LC-10 LD-7 LE0 LF1 LH85
N12 L"E" LA15 LC-10 LD-7 LE0 LF1 LH85
N13 L"N" LA15 LC-10 LD-7 LE0 LF1 LH85
N14 L"H" LA15 LC-10 LD-7 LE0 LF1 LH85
N15 L"A" LA15 LC-10 LD-7 LE0 LF1 LH85
N16 L"I" LA15 LC-10 LD-7 LE0 LF1 LH85
N17 L"N" LA15 LC-10 LD-7 LE0 LF1 LH85
N.. . . .