Maintenance, Fuses, Lights – Polaris 2016 Ranger 570 Full-Size User Manual
Page 76
74
MAINTENANCE
Fuses
If the engine stops or will not start, or if you
experience other electrical failures, a fuse may need
replacement. Locate and correct any short circuits
that may have caused the blown fuse, then replace
the fuse.
The fuse box is located in the electrical
compartment under the driver’s seat. Spare fuses
are provided in the fuse box.
If you suspect that a fuse or relay may not be
working properly, your POLARIS dealer can assist.
Lights
Poor lighting can result in reduced visibility when driving. Headlight and taillight lenses
become dirty during normal operation. Clean lights frequently and replace burned out lamps
promptly. Do not operate this vehicle at night or in low light conditions until the headlight is
replaced. Always make sure lights are adjusted properly for best visibility.
When servicing a halogen lamp, don't touch the lamp with bare fingers. Oil from your skin
leaves a residue, causing a hot spot that will shorten the life of the lamp.
Headlight Lamp Replacement
1. Access the headlamp wiring harnesses
through the front wheel wells.
CAUTION! Hot components can cause burns to skin.
Allow lamps to cool before servicing.
2. Unplug the headlamp from the wiring
harness. Be sure to pull on the connector, not
on the wiring.
3. Turn the lamp counter-clockwise to remove
it.
4. Install the new lamp.
Tip: Make sure the tab on the lamp locates properly in
the housing.
5. Reinstall the harness assembly into the
headlight assembly.
Fuse Size
Feature Supported
5A
Brake Light
10A
Drive System, Fuel Pump
20A
EFI, Power Steering (if equipped),
Lights, Accessories
20A Circuit
Breaker
Fan
Connector