Polaris 2016 Ranger 570 Full-Size - Manual (Page 27)

25
FEATURES AND CONTROLS
Seat Belts
This POLARIS vehicle is equipped with three-
point lap and diagonal seat belts on all seats.
Always make sure the seat belts are secured for all
riders before operating. The driver’s seat belt is
equipped with a seat belt interlock. Vehicle speed
will be limited to 15 MPH (24 km/h) if the seat belt
is not secured.
WARNING! Falling from a moving vehicle could result in
serious injury or death. Always fasten your seat belt
securely before operating or riding in the RANGER.
To wear the seat belt properly, follow this
procedure:
1. For 3-point belts, pull the seat belt latch
downward and across your chest toward the
buckle at the inner edge of the seat. The belt
should fit snugly across your hips and
diagonally across your chest. Make sure the
belt is not twisted.
2. Push the latch plate into the buckle until it
clicks.
3. Release the strap, it will self tighten.
4. To release the seat belt, press the square red button in the buckle’s center.
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly
into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage, including
cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not
operate properly, have the seat belt system checked and/or replaced by an authorized
POLARIS dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water.
Do not use bleach, dye or household detergents. Rinse the entire length of the belt
webbing. Use a garden hose to flush out the retractor and latch housings regularly.
Buckle
Latch Plate