Grass Valley RSAT2 - Manual (Page 24)

Remote Control Panel RSAT2 4. Operation
Operating Instructions - Rev. 1 / 11.2001 19
4.5 RSAT2 MACROS AND CONTROL PANEL M/E DELEGATION
When using the supplied exemplary makros, consider the following: the makros
have been programmed for the switcher type DD35-4. When using the makros for
the new switcher types DD35-2 and DD35-3 or in connection with the M/E delega-
tion, pay attention to the assignment of the M/E designation of the makro to the phy-
sical M/E of the control panel.
The supplied RSAT makros only function as usual when being used in a DD35-4
system and when the M/E control fields of the control panel are delegated 1:1 in
relation to the mainframe.
Assignment table
RSAT makros controlling parts of an M/E, have M/E designations relating to the
physical M/Es of the control panel.
There is the following assignment:
DD35-4 DD35-3 DD35-2 RSAT Makros
Physical Control Panel M/E RSAT makros are fixed-assigned to a physical
M/E
M/E1 me1_crs.sat
M/E2 M/E2 me2_crs.sat
M/E3 M/E3 M/E3 me3_crs.sat
PP PP PP pp_crs.sat
The physical M/E of the control panel, however, can control any mainframe M/E.
In this case, an RSAT makro acts on that mainframe M/E which is just delegated
in the physical M/E of the control panel.
Panel M/E1 is delegated to mainframe M/E3RPS35–3:
Panel M/E1 is delegated to mainframe M/E2
Panel M/E2 is delegated to mainframe M/E3
This workaround is only possible with full equipped mainframe!
Subsequent loading of RSAT2 macros does no more influence control panel soft-
ware stability.
Predefined macros got new names:
RSAT1 macro names are beginning with a ”1_”
RSAT2 macro names are beginning with a ”2_”.
RSAT1 Macros:
RSAT2 Macros: