Grass Valley RSAT2 - Manual (Page 16)

Remote Control Panel RSAT2 3. Installation and Startup
Operating Instructions - Rev. 1 / 11.2001 11
3.5 PORT RE-CONFIGURATION RS-422 / RS-232
In case the RSAT2 panel shall be used in connection with a PC, the port can be
configurated as RS-232. For this a RS-232 cable is nesseccary.
D
Demount the panel module.
D
Change the flat cable from RS-422/485 connector (right) to the RS-232 con-
nector (left).
D
Switch the port selection switch to the left position.
RS-422/485 connector
Port selection switch:
Left position: RS-232
Right position: RS-422/485.
RS-232 connector
Fig. 9: Changing the seriall part standard