Grass Valley RSAT2 - Manual (Page 18)

Remote Control Panel RSAT2 4. Operation
Operating Instructions - Rev. 1 / 11.2001 13
4. OPERATION
4.1 HOW TO START THE REMOTE PANEL
To start the protocol for the panel use the sidepanel menu. Step into the Install /
Panel / Satpanel menu and select the port number and the type of the protocol.
Fig. 10: DD35 install menu
After that the signal light of the remote panel has to be out. If it so, the panel is alive.
But if you do not have a macro file in your appli_cp.ini file the satellite panel will
be without any function. To add now the filename into the appli_cp.ini use the file
transfer program FTP to get the current appli_cp.ini and insert at the
[SAT_PANEL] under
filename = ”....”
the filename of the macro including the whole path.
E.g. filename = ”/flash/satpanel/me3_crs.sat” .
After the modification of the appli_cp.ini copy the file via FTP back into the mixer.
Now you should see the new function on the satellite panel.
After each new boot the file will be started automatically.