Electrolux ELECTRONIC BASIC IH 18 - Manual (Page 11)

11
Installation versions
For fittings directly on the appliance, the bushing openings pre-embossed in
the appliance hood must be cut out for the extension pipes of the fitting. The
supporting sheet (1) enclosed with the fitting fixes the extension pipes in
position and seals the housing openings. To ensure moisture protection,
the supporting sheet must be fitted.
Fitting must be vertically seated and
centrally under the appliance. Seal
appliance connection to the wall, where
necessary, with G 1/2 A blind plugs (2)
(fitting accessory).
If a cold water supply is made to the
appliance, the shutoff adapter (3) should be
replaced by an adapter with a wood screw
(4) for fixing the fitting in place.
Important! After completion of the water installation, the appliance
should be thoroughly flushed with cold water (open the hot water
valve). The strainer insert may possibly need cleaning afterwards.
1
2
3
4
The following tapping fittings are suitable:
D 169 - Special mixer tap with swivelling outlet
D 159 - Special shower mixer tap
D 149 - Special bath mixer tap with change-over tub/shower