Grass Valley Triton Plus Revision 3 - Manual (Page 22)

22 Triton Plus - Control Panels - User Manual
Control Panel Operation
Panel Enable
If a Panel Enable button is present, the panel will start up not enabled. In this
state the button will be red and all the other buttons will be disabled. When
pressing the button the panel will be enabled and the color will change to
green. A status request will also be sent to get information on active levels.
If no Panel Enable button is present, the panel will start up enabled.
Take On/Off
The Take On/Off button enables or disables the Take button. If no Take button
is defined, Take On/Off is always off. On first start-up the Take button is
enabled. Later it will read the last status from the flash memory.
Note Activating a GPI I/O will not influence the Take on/off function, nor will a Take
on/off function influence the activation of a GPI I/O function.
Take
The Take buttons LED is normally off. If the Take On/Off button is set to on, no
commands will be sent from the panel until the Take button is pressed. The
last selected buttons and the Take button will blink, until the Take button is
pressed and the command is sent from the panel.
Note Activating a GPI I/O will not influence the Take on/off function, nor will a Take
on/off function influence the activation of a GPI I/O function.
Output
An Output button is used for selecting an output. Selecting an output acti-
vates it, so that it is switched to the next input that is selected.
Input
An Inpu t button switches the active output to the selected input. If the Take
button is enabled, the switch will not be executed until the Take button is
pressed.
When switching using the Input button, all enabled audio- and video-levels
will be switched from the selected input to the active output.
Note The Input button can also be used to select the active output for single bus
panels and fallback inputs for GPI panels. Press and hold the Panel Enable
button while selecting the active output by pressing an Input button. Press
and hold the Panel Enable button while first toggling A/V Toggle and then
selecting the fallback input by pressing an Input button.
Unlike the buttons on the front of the panel, GPI inputs 1-32 cannot be recon-
figured to represent other inputs, i.e. they are fixed inputs (1-32), operating
on the selected output.