Grass Valley Triton Plus Revision 3 - Manual (Page 12)

12 Triton Plus - Control Panels - User Manual
Configuration
Fallback Mode
Note This information is applicable only on GPI versions.
Switch SW 5 on the configuration switch sets the fallback mode of the GPI
panel, either to dynamic or to hard-set .
Note This is only useful when the GPI panel is in Joystick release mode, see Joy-
stick Mode on page 14 .
Dynamic Fallback Mode
When the GPI is activated the X-point status is saved before switching.
When the GPI is released again, the panel will switch back to the previous
saved X-point status.
Hard-set Fallback Mode
When the GPI is released, the panel will switch to a previously configured
fallback input. The fallback input is configured using the input buttons, see
Button Description on page 21 .
The modes can be switched as described in Table 6 . The default mode is
Hard-set .
Table 6. Fallback Mode Switching
SW 5 Fallback Mode
Off Hard-set
On Dynamic