Grass Valley Triton Plus Revision 3 - Manual (Page 14)

14 Triton Plus - Control Panels - User Manual
Configuration
Joystick Mode
Note This information is applicable only on GPI versions.
Switch SW 8 on the configuration switch set the Joystick mode of the GPI
panel to either GPI Mode or to Joystick Release Mode .
GPI Mode
Releasing the input lines will keep the previous status. Operation of the
front panel is allowed with any number of active GPI-lines simultaneously.
Joystick Release Mode
When all the input lines are released, a default input (either dynamically
chosen or static) is set. The front panel is locked if any of the input lines are
active.
The modes can be switched with switch SW 8 according to the pattern given
in Table 9 . The default mode is GPI Mode (Off).
Configuring Output on Single Bus Panels
Refer to Input on page 22 for configuring default output to be controlled
from a single bus control panel.
Table 9. Joystick Mode Switching
SW 8 Joystick Mode
Off GPI Mode
On Joystick Release Mode