Grass Valley PLSDST3 - Manual (Page 16)

DST 312/412 Interface Kit Installation
10 DST 312/412 Interface Kit Installation
Installing the SCSI Adapter
The SCSI adapter board provides an EISA-to-SCSI interface that allows the
Media Manager or similar software on the Profile video file server to control the
ACL’s cartridge handling mechanism. The procedures that follow take you
step-by-step through the recommended sequence for installation of the SCSI
adapter board.
1. Remove the slot cover plate for slot J4 in the Profile video file server rear
panel.
➤ Important Be sure to remove the jumper as described in the following step.
If the jumper is left in place, the Profile video file server will display an error
when initializing the SCSI adapter board.
2. Unpack the SCSI adapter board and remove the jumper from W1 on the
board. Refer to the manual packed with the board to locate the jumper.
3. Plug the SCSI adapter board into the J4 socket and press down till the board
is fully plugged into the socket. The board is properly seated when the top of
the rear mounting bracket is resting on the rear chassis wall shelf.
4. Install the mounting screw only in the top of the bracket inside the cabinet
(as shown at ➊ in Figure 5).
5. Re-install the hold-downs. Align each hold-down over the circuit boards and
replace the mounting screws.
6. Re-install the cabinet covers. Do not tighten any of the screws until all the
screws are started.
7. Install the power cord, but do not turn on the Profile video file server.
Installing the Connecting Cables
In these procedures you install the cables that connect the Profile video file server
to the tape system. Use the procedure that applies to your installation. Consult
your tape system documentation for specific instructions before making any
connections.