Preparing the profile video file server, Figure 1. removing the top covers – Grass Valley PLSDST3 User Manual

Page 10

DST 312/412 Interface Kit Installation

Preparing the Profile Video File Server

Installing RAM on the Master or Slave EDR board and installing a SCSI adapter
board requires opening the Profile video file server and removing the circuit board
hold-down brackets. Use the procedures that follow to prepare the Profile video
file server for RAM and SCSI adapter installations.

1. Loosen the front panel retaining screw and pull the cabinet out until all three

slide sections latch.

2. Remove the top covers in the order shown in Figure 1. The front cover must

be removed first since it overlaps the rear cover. Use T-10 and T-15 TORX
drivers to remove the screws.

NOTE: Take care not to lose these cabinet screws. They are required to meet
the EMI specifications for the Profile video file server.

Figure 1. Removing the top covers

9675-9

This manual is related to the following products:

PLSDST4