beautypg.com

Figure 6. installing ram on the master edr board, Installing the ram – Grass Valley PLSDST3 User Manual

Page 15

background image

Installing the RAM

DST 312/412 Interface Kit Installation

9

5. Install the new RAM as shown in Figure 6. Sockets for I/O buffer RAM are

located in the same place on the Slave EDR board.

6. Re-install the EDR board, the PCI Interconnect board, and the SCSI cables.

Refer to Figure 4 for SCSI cable locations.

7. Install the retainer brackets, and the cabinet covers

unless

you have a SCSI

adapter board to install. If you have a SCSI adapter board to install, go on to
the next procedure, “Installing the SCSI Adapter”.

Figure 6. Installing RAM on the Master EDR board

0197-5

Notch

I/O Buffer

RAM

Notch

Local

Processor

RAM

Notch

This manual is related to the following products: